The International Simutrans Forum

PakSets and Customization => Pak128.Britain => Topic started by: prissi on May 09, 2013, 10:45:19 PM

Title: Clustering
Post by: prissi on May 09, 2013, 10:45:19 PM
I implemented the changes from neroden also in standard. Most importantly, I added a parameter to the cityrules.tab, cluster_factor. This is very much pakset dependent. If you use distribution weights of 100 and 10 for clustering buildings (to have only few isolated ones) you want to use values of 100.

Oviously it needs a new build of makeobj.
Title: Re: Clustering
Post by: The Hood on May 12, 2013, 08:53:23 PM
Looking forward to using this in pak128.Britain. Thanks for implementing - although it will be a while before I change this as I'm concentrating on vehicle balance at the minute...
Title: Re: Clustering
Post by: jamespetts on June 04, 2013, 11:41:43 AM
You can have a look at the implementation in Experimental (look at Neroden's modifications to it, too) - it should be already configured there, and can just be copied.