This is an articulated (two sections) bus that doesn't rely on electrification.
The NABI BRT 60 is used in Los Angeles for the Metro Rapid and the Metro Orange BRT Line
Image here: http://www.ngvglobal.com/images/stories/vehicles/NABI%2060ft%20BRT%20-%20CNG%20Powered.jpg (http://www.ngvglobal.com/images/stories/vehicles/NABI%2060ft%20BRT%20-%20CNG%20Powered.jpg)
Two sections, two pak files:(//)
you can merge the two pak files by using the MERGE command of makeobj.
Your bus takes far too much passengers and its running cost is far too much cheap. Not well balanced :/
Thanks for the advice, but it pretty much matches the Karosa buses from Cizurator
Quoteit pretty much matches the Karosa buses from Cizurator
(Did I miss something ??? )
take a look at these buses:
http://forum.simutrans.com/index.php?topic=2971.0 (http://forum.simutrans.com/index.php?topic=2971.0)
Then I think both are not well balanced. Take a look at Izzy's post right there
Quote from: Izzy on August 16, 2009, 01:23:56 PM
Also in my opinion you could try to match vehicle data with existing vehicles at the pak, your buses are to cheap in maintenance and in my opinion speeds are set to high.
They're the same suggestions as gauthier's.
@gauthier: I guess Freewayman used Karosa buses set as template.
??? I don't understand very well ??? (maybe because I'm tired).