Airplanes curiously take off after waypoint

[Václav]

One problem with waypoints in airplanes' lines was solved, but else appeared.

Now, landing by planes is still correct - but their taking off is not fully correct when waypoint says what runway has to be used. Airplanes go to the end of runway - and there they (without taking off) appear in sky - one tile back in length of runway.

Should be

        -----
      /
     /
-----


but is

   -----
   |     
    |
-----

where red vertical lines only show shift between end of runway and point where airplanes appear in air after they reach end of runway.

[Isaac Eiland-Hall]

Ah, you must be using the new BTOL (backward-take-off-and-landing) aircraft system that has replaced VTOL and STOL.

[Zeno]

Don't use waypoints in runways; use them in taxiways instead. If I remember correctly, that kind of effect could be caused by the route calculation that happens when an airplane reaches a waypoint.

[Václav]

Zeno, I use them on taxiways - on the first tile by its crossing with runway.

[prissi]

That should be fixed too in r7345