The International Simutrans Forum

 

Author Topic: 121.0 - Display reservation  (Read 386 times)

0 Members and 1 Guest are viewing this topic.

Offline Andarix

  • *
  • Posts: 69
121.0 - Display reservation
« on: December 24, 2019, 01:12:52 PM »
Strange display of the reservation. In the tunnel there is a signal on the rear track directly in front of the tunnel portal.




Offline Andarix

  • *
  • Posts: 69
Re: 121.0 - Display reservation
« Reply #1 on: December 27, 2019, 07:02:01 PM »
This is not just a display error, it also blocks overlying routes.



On the other hand, the freight train cannot find its way through the station. It is a passing train. I could observe this behavior several times, the train was blocked even though there were free tracks to drive past.


Offline Vladki cz

  • Devotee
  • *
  • Posts: 2798
    • My addons, mostly roadsigns, pak128.cs
  • Languages: EN, CS
Re: 121.0 - Display reservation
« Reply #2 on: December 29, 2019, 11:19:54 AM »
Choose signals do not affect through trains. They always wait for the shortest path to be clear. (But in extended it works also for through trains)

Offline Andarix

  • *
  • Posts: 69
Re: 121.0 - Display reservation
« Reply #3 on: December 29, 2019, 11:28:11 AM »
Choose signals do not affect through trains. They always wait for the shortest path to be clear. (But in extended it works also for through trains)

An end_of_choose signal is set after the train station.

The behavior does not only occur with choose signals. There I had to force the free through tracks with waypoint.

Offline prissi

  • Developer
  • Administrator
  • *
  • Posts: 9631
  • Languages: De,EN,JP
Re: 121.0 - Display reservation
« Reply #4 on: December 29, 2019, 09:07:25 PM »
End of choose will stop the choosing. The train might still wait for the entire route until the next stop to be free (depending on signals etc). It will just not attempt to find an alternative route.

Do not use choose signals in through stations without waypoints.

The display error might come from the fact that the ground tile of a tunnel exit is outside, and flat but too low.

Offline Dwachs

  • DevTeam, Coder/patcher
  • Administrator
  • *
  • Posts: 4614
  • Languages: EN, DE, AT
Re: 121.0 - Display reservation
« Reply #5 on: January 06, 2020, 10:31:20 AM »
There is a bug: the reservation of the first tunnel tile is show on the surface. This is purely graphics. No tiles on the surface are reserved.