r2140+pak64 r115 - wrong smoke position (makeobj)

[z9999]

simutrans r2140 + pak64 r115 (downloaded from nightly site)

Position of industry smoke is wrong.
This problem happens with pak64 downloaded from nightly site.

I think this is makeobj problem which was changed in simutrans r1960.
This problem doesn't happen with pak64 compiled by sourceforge version of makeobj.
I compiled makeobj from r2140 source code, and same problem happened.

[prissi]

yes, only twice x-offset was saved.

[z9999]

Pak64 101-1 on sourceforge has this problem.
Didn't you compile a new makeobj ?

... and why 101-1 ?

[prissi]

Typo ... and I compiled with the wrong makeobj aparently. I did not notify the downloader yet for this and other reasons though.